泰安附近想过夜电话联系

Wuzhong buried water tank | Wuzhong stainless steel water tank | Wuzhong water tank shall be selected according to the drawing

  • Place of Origin:
  • Capacity:
  • Material Science:
  • Brand:
product details

Wuzhong buried water tank| Wuzhong stainless steel water tank | Wuzhong water tank Select by drawing

1、 The embedded water tank module uses hot-dip galvanized steel plate or stainless steel plate, which is pressed and molded by press equipment to make it closely cooperate, so as to meet the requirements of steel plate material strength and corrosion resistance of stainless steel.  
2、 After pressing and forming, punching is carried out through equipment to meet the assembly requirements of standard modules.  
3、 On site assembly and foundation channel steel shall be subject to national standard hot-dip treatment, and each beam shall be assembled with a spacing of 1 m, and so on.  
4、 According to the requirements of the atlas, it is assembled with hot-dip galvanized screw and water-resistant adhesive tape. After the water tank is assembled and shaped, the tie bar and top column are installed. The hot-dip galvanized tension bar is selected, and the cross installation is less than 1 meter. Hot dip galvanized pipe is selected for the top column, and 4 pipes per square meter are evenly distributed and sealed.  
5、 Check the inside of the pump house with I-shaped steel, and check if there is no screw missing after the pump station is installed.  
6、 Clean the remaining fittings in the water tank.  
7、 Wuzhong stainless steel water tank is covered with soil and site preparation work is done.
Note: description
1. The water in the pit should be pumped out before the buried stainless steel water tank is covered with soil.
2. There is no fine earth covered with stone;
3. When covering soil, the excavator should not be too close to the water tank, and the excavator cannot walk above the water tank;
4. When Wu Zhong buried water tank is covered with soil, soil should be added from all sides, and the soil should be added in a circle of 50cm until it is parallel to the ground.

Related products